Decompilation & Disassembly prohibited..

View Comments

• MY COMPUTER NOT WORKING PLEAS HELP
  ON SCREEN MSG INTEL (R) Q33/Q35/G33 PCI ACCELERATED SVGA BIOS DECOMPILATION OR DISSEMBLY PROHIBITED

• Hi Everyone, how are you? This morning I have tried to turn the laptop on and I fond this writing in the laptop too. I take away the battery and insert it again, the same with hardware,m but still the same problem. What should i do???

  thank you.

• gençler nedir bu hata?çözümü var m?d?r?yok mudur?yard?m edecek biri yok mu yahu?

• Hey my system suffers from the same problem. Can any one help me if u have any suggestion for this problem then reply on jitendrasingh076@gmail.com please guys help me

• hi guys there is the solution, good luck
  http://en.community.dell.com/support-forums/desktop/f/3514/p/18701213/18824199.aspx

• I had the same problem. It's very easy to repair: Just stop the computer, unplug the power cord, remove all the memory modules from the mother board, start the computer, stop the computer, replace all the memory modules, restart the computer.
  Then It should be OK.

• same problem

• solucione el problema muy facilmente, rece 4 padrenuestros, 8 avemarias y listo, funciona
  perdon tb cambie el monitor y solucionado el problema

• Shut down the PC, unplug the power cord and hold the power button in for 15 seconds.

  Open the case and remove the cmos battery for 15 Minutes (note the polarity of the battery before removal) Replace the battery if it is 3-5 years old. Reinsert the battery after 15 Minutes, close the case and plug it in, then do the following before doing anything else.

  Power up the PC
  * Watch the keyboard lights. When they flash, tap the F2 key
  * The message, Entering Setup should appear
  * Down arrow to Maintenance
  * Choose Load Defaults
  * Click Continue - Restore factory defaults

  Restart the PC, see if the message is gone.

• Just turn off your computer, unplug power cord then plug it back in, open your computer and press Del. as fast and as much as you can, some computer might be F2 or F10. Then you are in BIOS, dont need 2 do anything, just save and exit.